LJ Relays (Instructional Manual)

INSTRUCTION MANUAL

Although every effort is made to provide an accurate and detailed instruction manual, it is not possible to cover all possible contingencies which may arise during installation, operation, or maintenance. If there are any question, please contact your local Relay Associates representative or Relay Associates directly at 610-941-2900.

The LJ relay is a high speed, high inertia auxiliary relay designed to operate in 4 milliseconds*. The relay can be configured with any of its two (2) six (6) or ten (10) contacts normally open or normally closed. The dustproof, all aluminum case is available in both flish or projection mount configurations. The patented shielded coil minimizes internally generated transients and provides immunity to misoperation from system transients.

Click here to view PDF of full Instruction Manual.

The different models can be identified by referring to the table below.

Note 1. FT11 Front Panel fits FT11 Cutout (not available with the LJ23).
Note 2. HFA Front Panel fits HFA Flush mount non-drawout cutout (not available with the LJ23).
Note 3. Selecting the seal-in unit reduces usable contacts by one. Not available on projection mount units.
Note 4. Summation of N/O and N/C contacts cannot exceed 2 for LJX1 models, 6 for LJX2 models, and 10 for LJX3 models.
Note 5. 48 Volt Operating Coil is available be special order. Consult factory.
Note 6. Two contact Units only available on LJ4X models.

Contact Relay Associates for more information.